Updated Apr 01, 2022 Verified HPE6-A75 dumps Q&As - 100% Pass
New 2022 Latest Questions HPE6-A75 Dumps - Use Updated HP Exam
NEW QUESTION 35
An administrator wants to implement bandwidth limits for guest users to restrict their Internet usage. On the Mobility Master (MM), where would the administrator define these limits?
- A. 802.1X policy
- B. Firewall policy
- C. AAA policy
- D. User role
Answer: B
NEW QUESTION 36
A network administrator can set the OSPF metric-type on an AOS-Switch to Type 1 or Type 2. What is the difference?
- A. A Type 2 metric is assigned to multiple external routes that are aggregated together, while a Type 1 metric does not permit external route aggregation.
- B. A Type 2 metric assigns cost 1 to a 100 Gbps link, while a Type 1 metric assigns cost 1 to all links of 100 Mbps or higher.
- C. A Type 2 metric marks external routes that can be advertised in NSSAs, while a Type 1 metric marks external routes that can only be advertised in normal areas.
- D. A Type 2 metric stays the same as the external route is advertised, while a Type 1 metric increments with internal OSPF link costs.
Answer: D
NEW QUESTION 37
A network administrator wants to use Aruba AirWave to audit an AOS-Switch configuration. What rs one requirement?
- A. The switch specifies the AirWave IP address for the RADIUS server used for Telnet and SSH authentication.
- B. The switch is authorized in AirWave, which has the correct credentials to log in as a CLI manager.
- C. The switch defines the AirWave IP address in its zero touch provisioning (ZTP) profile.
- D. The switch is set to Manage Read-Write mode in AirWave but is not set to Monitor Only + Firmware Updates.
Answer: A
NEW QUESTION 38
What is a primary use case for RPVST+ on AOS-Switches?
- A. more granular load balancing than MSTP when access switches connect to two core switches
- B. integration of AOS-Switches in a heterogeneous vendor network that uses the Cisco protocol
- C. enhanced loop protection in an MSTP network
- D. seamless integration with RSTP
Answer: B
NEW QUESTION 39
An administrator supports a RAP to a branch office. Employees at the branch office connect to an employee SSID that allows for split tunneling of the employee traffic. The RAP initially connects to the corporate office controller, but later loses connectivity to it.
Which operating mode should the administrator configure for a secondary SSID to be advertised during the loss of connectivity?
- A. Standard
- B. Backup
- C. Persistent
- D. Always
Answer: C
NEW QUESTION 40
A university wants to deploy ClearPass with the Guest module. They have two types of users that need to use web login authentication. The first type of users are students whose accounts are in an Active Directory server. The second type of users are friends of students who need to self-register to access the network.
How should the service be setup in the Policy Manager for this Network?
- A. Active Directory server as the authentication source, and Guest User Repository as the authorization source
- B. Guest User Repository as the authentication source and the Active Directory server as the authorization source
- C. Guest User Repository and Active Directory server both as authentication sources
- D. Guest User Repository as the authentication source, and Guest User Repository and Active Directory server as authorization sources
- E. Either the Guest User Repository or Active Directory server should be the single authentication source
Answer: C
NEW QUESTION 41
Refer to the exhibit.
The network administrator wants to reduce failover time If a switch link m VIAN 100 goes down. What should the administrator do?
- A. Configure echo mode BFD on VLAN 100 on all OSPF routing devices on VLAN 100.
- B. Lower the dead timer on the BDR of VLAN 100.
- C. Lower the hello timer only on the BDR of VLAN 100.
- D. Configure graceful restart on all of the OSPF routing devices on VLAN 100.
Answer: A
NEW QUESTION 42
A company has AOS-Switches deployed at sites with inexperienced IT staff. The main office network administrators want to track if configurations change on branch switches. What should be set up for this purpose?
- A. an RMON alarm
- B. an lP SLA profile
- C. an SNMP trap
- D. an auto-config server
Answer: C
NEW QUESTION 43
Refer to the exhibit.
Based on the configuration of the Enforcement Profiles In the Onboard Authorization service shown, which Onboarding action will occur?
- A. The device will be disconnected from and reconnected to the network after Onboarding is completed.
- B. The device's onboard authorization request will be denied.
- C. The device will be disconnected from the network after Onboarding so that an EAP-TLS authentication is not performed.
- D. After logging in on the Onboard web login page, the device will be disconnected form and reconnected to the network before Onboard begins.
- E. The device will be disconnected after post-Onboarding EAP-TLS authentication, so a second EAP-TLS authentication is performed.
Answer: A
NEW QUESTION 44
Refer to the exhibit.
Traffic between the servers m Area l takes a less optimal path rather than the link associated with VLAN l OOO, subnet 10.0.0.0/30. Based on the exhibits, why is this the case?
- A. Switch-1 and Switch-2 cannot achieve adjacency on VLAN 1000 due to mismatches.
- B. The metric on the VLAN 1000 interface is too low.
- C. OSPF routing switches choose the best intra-area routes based on Area 1 links only.
- D. The link between Switch-1 and Switch-2 has gone down.
Answer: C
NEW QUESTION 45
What must an OSPF router do when it receives a link state update?
- A. It must participate in a new election for the Designated Router and Backup DR.
- B. It must run the shortest path first algorithm.
- C. It must re-establish adjacency with its Designated Router and Backup DR.
- D. It must initiate a graceful restart timer.
Answer: B
NEW QUESTION 46
An administrator configures an ArubaOS-Switch for per -user tunneled node. Which protocols does the switch use to establish and maintain a connection with the Aruba Mobility Controller (MO? (Select two.)
- A. SSL
- B. GRE
- C. PAPI
- D. IPSec
Answer: B,C
NEW QUESTION 47
Refer to the exhibit.
Based on the configuration for the client's certificate private key as shown, which statements accurately describe the settings? (Select two.)
- A. The private key is stored in the ClearPass server.
- B. More bits in the private key will reduce security.
- C. The private key for TLS client certificates is not created.
- D. The private key is stored in the user device.
- E. More bits in the private key will increase security.
Answer: D,E
NEW QUESTION 48
Refer to the exhibit.
An administrator implements AP licensing on a Mobility Master (MM).
* Each campus is responsible to purchase its own AP licenses.
* There are 900 AP licenses deployed in the global pool
* There are three dedicated pools.
* From the global pool, 300 AP licenses are assigned to each dedicated pool.
Network engineers at CampusA want to deploy an additional 100 APs. Currently all of the AP licenses in CampusA and CampusB are allocated, but only 200 of the AP licenses m CampusC are allocated.
What can the administrator do to add capacity for CampusA in alignment with campus policies?
- A. Move 100 licenses from the CampusC pool to the global pool.
- B. Add 100 more AP licenses and assign them to the CampusA pool.
- C. Allow CampusA to share from the CampusC pool.
- D. Add 100 more AP licenses to the global pool.
Answer: B
NEW QUESTION 49
Which statement is true about the Endpoint Profiler? (Select two.)
- A. Data obtained from the Endpoint Profiler can be used in Enforcement Policy.
- B. The Endpoint Profiler requires the Onboard license to be enabled.
- C. The Endpoint Profiler can only categorize laptops and desktops.
- D. Endpoint Profiler requires a profiling license.
- E. The Endpoint Profiler uses DHCP fingerprinting for device categorization.
Answer: A,E
NEW QUESTION 50
Refer to the exhibit.
Controllers are configured m a cluster as shown in the exhibit. These are the network details.
* A Mobility Master (MM) manages the cluster.
* The cluster contains two controllers: C l and C2.
* API and AP2 use CI as their Active AP Anchor Controller (A-AAC). with C2 as their Standby AAC (S-AAC).
* AP3 and AP4 use C2 as their A-AAC, with CI as their S-AAC.
User1 establishes a wireless connection via API, where the Active User Anchor Controller (A-UAC) assigned is CI. with C2 as the standby. What happens when User I roams the wireless network and eventually their session is handled by AP3?
- A. The AP3's A-AAC switches to C1, and the user's A-UAC remains on C1.
- B. The AP3's A-AAC switches to C2, and the user's A-UAC remains on C2.
- C. The AP3's A-AAC switches to C1, and the user's A-UAC remains on C2.
- D. The AP3's A-AAC switches to C2, and the user's A-UAC remains on C1.
Answer: B
NEW QUESTION 51
Refer to the exhibit.
An Enforcement Profile has been created in the Policy Manager as shown. Which action will ClearPass take based on this Enforcement Profile?
- A. ClearPass will count down 600 seconds and send a RADIUS CoA message to the NAD to end the user's session after this time is up.
- B. ClearPass will send the Session-Timeout attribute in the RADIUS Access-Request packet to the NAD and the NAD will end the user's session after 600 seconds.
- C. ClearPass will count down 600 seconds and send a RADIUS CoA message to the user to end the user's session after this time is up.
- D. ClearPass will send the Session-Timeout attribute in the RADIUS Access-Accept packet to the NAD and the NAD will end the user's session after 600 seconds.
- E. ClearPass will send the Session-Timeout attribute in the RADIUS Access-Accept packet to the User and the user's session will be terminated after 600 seconds.
Answer: D
NEW QUESTION 52
Which is a valid policy simulation types in ClearPass? (Select three.)
- A. Role Mapping
- B. Endpoint Profiler
- C. Enforcement Policy
- D. Chained simulation
- E. Posture token derivation
Answer: A,C,D
NEW QUESTION 53
Refer to the exhibit.
Which statements accurately describe the status of the Onboarded devices in the configuration tor the network settings shown? (Select two.)
- A. They will connect to Employee_Secure SSID for provisioning their devices.
- B. They will use WPA2-PSK with AES when connecting to the SSID.
- C. They will connect to Employee_Secure SSID after provisioning.
- D. They will perform 802.1X authentication when connecting to the SSID.
- E. They will connect to secure_emp SSID after provisioning.
Answer: D,E
NEW QUESTION 54
An administrator needs to authenticate users connected to an ArubaOS Switch where the switch authenticates the user, assigns the firewall policies to the user, and processes some of the users' traffic. Which connection method should the administrator configure on the ArubaOS-Switch?
- A. Per-user tunneled node
- B. Per-port tunneled node
- C. Split-tunneled mode
- D. VLAN tunneled mode
Answer: B
NEW QUESTION 55
A customer wants to implement Virtual IP redundancy, such that in case of a ClearPass server outage, 802.1x authentications will not be interrupted. The administrator has enabled a single Virtual IP address on two ClearPass servers.
Which statements accurately describe next steps? (Select two.)
- A. The NAD should be configured with the primary node IP address for RADIUS authentication on the 802.1x network.
- B. The NAD should be configured with the Virtual IP address for RADIUS authentications on the 802.1x network.
- C. The primary node will respond to authentication requests sent to the Virtual IP address when the primary node is active.
- D. A new Virtual IP address should be created for each NAD.
- E. Both the primary and secondary nodes will respond to authentication requests sent to the Virtual IP address when the primary node is active.
Answer: B,C
NEW QUESTION 56
An administrator supports a cluster of four Aruba Mobility Controllers (MCs) with management addresses of 10.1.100.101, 10.1.100.102, 10.1.100.103, and 10.1.202.181. The administrator accesses an AP associated with this cluster, reboots it and accesses apboot mode. The administrator executes the printenv command. Which AP parameter contains the IP addresses of the cluster members that the AP should use to connect to the cluster?
- A. Noodelist
- B. Master_ip
- C. Servername
- D. Cfg_lms
Answer: A
NEW QUESTION 57
Refer to the exhibit.
The network administrator needs to set up BGP between the two company switches. Switch-1 and Switch-2. The BGP connection does not establish. Based on the exhibits, what does the administrator need to do to fix the issue?
- A. Enable BGP on the interfaces that the switches use to reach each other.
- B. Enter the network command for 10.0.0.0/24 in the router BGP mode on each switch.
- C. Enable the multihop option for the neighbor on each of the switches.
- D. Set the update source for the neighbor to the local loopback interface on each switch.
Answer: D
NEW QUESTION 58
Refer to the exhibit.
Based on the Policy configuration shown, which VLAN will be assigned when a user with ClearPass role Engineer authenticates to the network successfully on Saturday using connection protocol WEBAUTH?
- A. Full Access VLAN
- B. Internet VLAN
- C. Deny Access
- D. Employee VLAN
Answer: D
NEW QUESTION 59
......
HP HPE6-A75 Exam Syllabus Topics:
| Topic | Details |
|---|---|
| Topic 1 |
|
| Topic 2 |
|
| Topic 3 |
|
| Topic 4 |
|
| Topic 5 |
|
| Topic 6 |
|
| Topic 7 |
|
Latest HPE6-A75 Exam Dumps HP Exam from Training: https://realpdf.pass4suresvce.com/HPE6-A75-pass4sure-vce-dumps.html